- Arch Linux
- #1 2014-01-16 05:42:14
- Nouveau errors (MMIO write FAULT) and usb string descriptor malformed
- Linux Mint Forums
- Nouveau crashes system intermittently
- Nouveau crashes system intermittently
- Linux Mint Forums
- [SOLVED] Problem with video-driver may be
- [SOLVED] Problem with video-driver may be
- Re: Problem with video-driver may be
- Re: Problem with video-driver may be
- Re: Problem with video-driver may be
- Re: Problem with video-driver may be
- Re: Problem with video-driver may be
- Re: Problem with video-driver may be
- Re: [SOLVED] Problem with video-driver may be
- Как понять почему постоянно падает Лиса и как этого избежать?
- Linux Mint Forums
- [Solved] new Delay and ACPI related error during boot after upgrade from 18.3 to 19
- [Solved] new Delay and ACPI related error during boot after upgrade from 18.3 to 19
- Re: new Delay and error during boot after upgrade from 18.3 to 19
- Re: new Delay and ACPI related error during boot after upgrade from 18.3 to 19
Arch Linux
You are not logged in.
#1 2014-01-16 05:42:14
Nouveau errors (MMIO write FAULT) and usb string descriptor malformed
Here’s a bit of system information that’s useful:
— My laptop uses Optimus between the CPU (4700MQ) and the GPU (NVIDIA 770M)
— I’m currently running Manjaro (blasphemy, I know) using the non-free NVIDIA drivers with bumblebee for Optimus (which works very well)
I’m going to move to Arch from Manjaro, but there seem to be a few issues with my boot process (even on the USB drive).
I get these errors on boot of Arch (taken from dmesg —level=err):
Also in the warnings (only the nouveau entry):
Clearly, the nouveau errors come from the open source drivers, but I’m not sure what’s causing them. The warning about the voltage table comes before the errors, which is interesting. On my Manjaro installation, I couldn’t get the open source drivers to work with bumblebee, so switched to the non-free NVIDIA drivers which ended the errors (since nouveau isn’t loaded), and then I could run processes on the GPU with Optimus. Clearly, my reference here is Manjaro, but the errors persist between both.
As for the string descriptor 0 malformed, I have no clue. This happens both on Arch and Manjaro, however it hasn’t cause any specific issue, but it is something I have to look at on my boot up, which isn’t nice.
Can anyone guess as to the source of the errors?
EDIT: Here is the output of «dmesg | grep nouveau» which gives all the nouveau output during boot: http://pastebin.com/wQiuwApk
Last edited by zikaeroh (2014-01-16 05:46:52)
Источник
Linux Mint Forums
Welcome to the Linux Mint forums!
Nouveau crashes system intermittently
Nouveau crashes system intermittently
Post by Thanks for the Fish » Sun Jul 11, 2021 3:06 pm
Good evening!
a while ago, my system began to freeze intermittently after a certain update and hard resets are the only option left. I have the impression that the crashes occur regardless of the user input (or the lack thereof). Unfortunately, I don’t remember wether this began after one of the last kernel updates or after the last nouveau update. I studied several similar support requests from other users but this situation seems to be a tad different — hence this thread.
I’m using.
- Linux mint mate 19.3
kernel: 4.15.0-147-generic x86_64.
libdrm-nouveau2: 2.4.101-2
18.04.1
X.Org: 1.19.6
x11proto-xf86vidmode-dev: 2018.4-4
xserver-xorg-video-nouveau: 1:1.0.15-2
mesa-vulkan-drivers: 20.0.8-0ubuntu1
18.04.1
output of sudo inxi -Fxz:
I tried the earlier kernel 4.15.0-142 without any improvements. A memory test was also inconclusive. The proprietary Nvidia driver is no longer maintained
The last lines in the kernel logs before the crash almost always look like this (complete log-files for the kernel and x are below):
Let me know if you need anything else. Any help is much appreciated — this problem makes the machine pretty much useless.
Источник
Linux Mint Forums
Welcome to the Linux Mint forums!
[SOLVED] Problem with video-driver may be
[SOLVED] Problem with video-driver may be
Post by finalist » Sat Jul 23, 2016 3:30 pm
Re: Problem with video-driver may be
Post by Laurent85 » Sat Jul 23, 2016 4:31 pm
Re: Problem with video-driver may be
Post by finalist » Sat Jul 23, 2016 4:44 pm
I see available drivers for my Nvidia graphics card:
NVIDIA Corporation: C61 [GeForce 6150SE nForce430]
1. nvidia-304 (recommended)
— not in use;
2. xserver-xorg-video-nouveau (open source)
— in use;
3. nVidia-304-updates
— not in use;
Unknown
This device is not working
amd64-microcode
— not in use
— Do not use this device;
Re: Problem with video-driver may be
Post by richyrich » Sat Jul 23, 2016 5:14 pm
Re: Problem with video-driver may be
Post by Laurent85 » Sat Jul 23, 2016 5:16 pm
Re: Problem with video-driver may be
Post by finalist » Sat Jul 23, 2016 6:36 pm
NVIDIA Corporation: C61 [GeForce 6150SE nForce430]
1. nvidia-304 (recommended)
— in use;
Unknown
This device is not working
amd64-microcode
— in use;
Re: Problem with video-driver may be
Post by finalist » Sat Jul 23, 2016 6:42 pm
Re: [SOLVED] Problem with video-driver may be
Post by elbarbudo » Sun Nov 18, 2018 3:11 am
NOT SOLVED!
I just made a fresh install of Linux Mint 19 TARA and I got the issue.
The driver is nouveau
The driver-manager does not show any NVIDIA card
Источник
Как понять почему постоянно падает Лиса и как этого избежать?
Доброве время суток, уважаемое сообщество!
Arch, Inspiron 3543, Nvidia 820M (nouveau).
На ноуте указанном выше свеже поставленный Арч. Постоянно падает Лиса. Где-то читал что может быть из-за драйверов GPU.
в journalctl вижу:
Через 6 секунд запись:
Помогите пожалуйста определить проблему падений! Арч ставится не первый раз и по арчвики, на других архитектурах такого никогда небыло.
Ну сам же причину нашёл, ставь закрытый драйвер, только из репозироия, а не инсталлером с сайта.
Ну я пока не понимаю в чем именно трабла.
Гугление по libxul.so дает только то, что лиса тупо не запускается, а не падения оной.
Причина в том, что швабодные дрова кривые.
Запусти в безопасном режиме для верности диагностики проблемы.
Снес nouveau, поставил проприетарный блоб из реп (375.20-3 ), mkinitcpio , reboot и арч развалился.
Загрузился с флехи, сделал arch-chroot в Ось, снес это проприетарное поделие и теперь снова могу сюда писать 🙂
Ну это у тебя оптимус значит. Другой вопрос, зачем и как ты запускал браузер на дискретке.
Никак, никаких PRIME и тому подобное. Просто из гнума или терминала. Я поэтому и не стал сразу грешить на дрова.
А если без шуток, то пробуй запускать лису с новым профилем и смотри, будут ли падения.
А можно поподробнее?
Я лису знаю ровно настолько что бы писать сюда.
Проверю может сейчас падений не будет 🙂
Падает. Видимо дело не в дровах.
Перезапусти Firefox в Safe mode.
Help -> Restart with Add-ons Disabled.
Ну падает и с другим профилем:
На дебиане 8 постоянно падал iceweasel, особенно на википедии. Оригинальный firefox не падает.
Переехал пока на Chromium.
Та же проблема на AltLinux 7.0.5 SPT (silo) 32-bit, Firefox последний из репозитория 52.8.0 (32bit).
Падает при нажатии f12, а также, например, при поиске дополнений https://addons.mozilla.org/en-US/firefox/?utm_source=discovery.addons.mozilla. при вводе строки поиска.
Скачанная с офф сайта последняя версия эту ошибку не показывает, но зато криво работает с радио-кнопками и чекбаксами — отмечает все визуально, при нажатии не снимает отметку визуально, но работает. просто не видно что выбрано.
Скачанная с офф сайта последняя версия эту ошибку не показывает, но зато криво работает с радио-кнопками и чекбаксами — отмечает все визуально, при нажатии не снимает отметку визуально, но работает. просто не видно что выбрано.
это было в Mate, в LXDE под АльтЛинукс нормально. Правда в LXDE неуобно работает пакман и тунар с сетевыми папками samba
Потестируй работу в чистом профиле. Если будет так же падать, то скорее всего проблема с видеодровами.
Источник
Linux Mint Forums
Welcome to the Linux Mint forums!
[Solved] new Delay and ACPI related error during boot after upgrade from 18.3 to 19
[Solved] new Delay and ACPI related error during boot after upgrade from 18.3 to 19
Post by typematrix » Sat Jul 07, 2018 11:52 am
I upgraded from 18.3 XFCE LTS to 19 XFCE as per official guide.
I am running laptop, Dell latitude 5440
My boot time as gone up about 20 seconds.
During boot the machine pauses on
ACPI — ACPI /_SB_,PCIO.RP05.PEGP failed to evalute _DSM.
for 20 about seconds then boots successfully. this is where the new delay is
Anyone know what’s causing the ACPI errors?
Here is a github gist with output of
systemd-analyze time
systemd-analyze critical-chain
systemd-analyze blame
https://gist.github.com/gavinlyonsrepo/ . 0cbd869366
Re: new Delay and error during boot after upgrade from 18.3 to 19
Post by Flemur » Sat Jul 07, 2018 1:28 pm
You don’t need :
6.328s NetworkManager-wait-online.service
You probably don’t need ModemManager.service although the writeup makes it sound important:
https://www.freedesktop.org/wiki/Software/ModemManager/
I disabled and apparently didn’t need:
842ms keyboard-setup.service
Although they don’t take up much time, you also don’t need any virtualbox services until you start virtualbox.
When I was using vbox, I disabled
vboxautostart-service.service
vboxballoonctrl-service.service
vboxweb-service.service
vboxdrv.service
and started them just before starting vbox.
Re: new Delay and ACPI related error during boot after upgrade from 18.3 to 19
Post by typematrix » Mon Jul 09, 2018 2:06 pm
The machine pauses on ACPI /_SB_,PCIO.RP05.PEGP failed to evalute _DSM. during loading of kernal modules at boot.
Anyone know what these messages mean? : Output of journalctl -p 3 -xb
Источник
